9
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
ADDING THE FUEL/OIL MIXTURE
The generator requires a 50:1 mixture of fuel and oil. To mix the fuel you will
need a 5L container with a screw-on lid suitable for storing petrol.
1. Pour the required amount of petrol into the container.
• Your generator has been designed to use regular unleaded petrol
with an octane rating of 86 or higher.
2. Remove the fuel cap from the
generator.
3. Use the fuel cap to measure the
required amount of oil.
• Add 0.02L of oil to every litre of
fuel.
IMPORTANT: Only use approved two
stroke engine oil, standard engine oil
is not suitable.
Replace the lid on the container hold-
ing the petrol/oil mixture and shake the
container to mix the contents.
4. Slowly pour the mixture into the
fuel tank (maximum 4.2L)
• Do not overfill the fuel tank.
5. Replace the fuel cap securely.
WARNING: FUEL IS HIGHLY FLAMMABLE AND POISONOUS.
WARNING: SEE “GENERAL SAFETY RULES” ON PAGE 4 AND READ THEM
CAREFULLY BEFORE REFUELING.
WARNING: WIPE UP ANY SPILLED FUEL IMMEDIATELY.
WARNING: AFTER REFUELING, MAKE SURE THE FUEL CAP IS TIGHTENED
SECURELY.
Amount of Fuel Add this much Oil
1L 0.02L
2L 0.04L
3L 0.06L
4L 0.08L
To Next Page
Loading...
Need help?
General
