23
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The generator
fails to start
Engine s
witch is off Set the engine switch to ‘on’
Not enough oil in the
generator
Add more oil, Se
e page 11
No fuel Add more fuel, See page 12
Spark plug not working
corr
ect
ly
Change the spark plug, See
page 21
The generator
fails to
generate
electricity
The device you are trying
to power is faulty
Make sure the device you want
to power is working properly
The overload indicator is
on
Remove the appliance
imme
diately, do not connect
any appliance that requires
more than 1200W.
(DC supply only) The DC
O
v
erload protector has
activated.
Press the reset button. See
page 17
The generator is
difficult to start
The air filter is dirty Clean the air filter. See page 20
If this does not solve your problem, please contact the Clarke service
department. see below.
To Next Page
