10
WARNING: IF ANY PART IS MISSING OR DAMAGED, DO NOT PLUG THE
MACHINE IN UNTIL THE MISSING OR DAMAGED PART IS REPAIRED OR
REPLACED AND ASSEMBLY IS COMPLETE.
TOOLS NEEDED FOR ASSEMBLY
• Adjustable wrench or socket set
• Cross-head screwdriver
• Hammer and block of wood
INSTALLING THE BASE AND COLUMN
NOTE: Ideally, the base should be firmly bolted
to the floor or workbench, prior to assembly of
other components. The mounting surface must
flat, level and capable of supporting the ma-
chines weight. The machine should be securely
fastened through the mounting holes to a stand
or floor with heavy-duty fasteners (not supplied).
This will prevent the machine from tipping over,
sliding, or walking during operation.
1. With the base on a flat level surface, bolt on
the column using the 4 x M10 Hex head bolts
(1) provided and tighten them fully.
Fig 1
ASSEMBLY
ITEMS SUPPLIED LOOSE IN THE BAG OR BOX
To Next Page
