14
To disconnect the chuck from the arbour, give it a sharp tap with a soft head
mallet to break the taper seal.
NOTE: Morse taper drills (MT2), may also be used with this machine, and are
inserted into the quill to replace the arbour. Removal is the same as that for
removing the chuck.
ASSEMBLING THE ON/OFF SWITCH
Ensure the ON/OFF switch ‘Emergency OFF’
component is attached, as shown, using the two
screws supplied. Make sure the plastic cover is
properly in place before running the machine.
To turn the machine ON, lift the cover guard to
access the ON/OFF buttons. Press the green
push-button to start the machine.
• As a safety feature, the ON button cannot
be pressed without raising the guard.
To turn OFF, press either the OFF button if holding
the guard raised, or press the guard cover at any time.
Fig 8
USEFUL ACCESSORIES
The following range of accessories is available from your Clarke dealer:
Mortising Attachment CMA1B 6500023
Mortise Chisels 6mm 6500025
9mm 6500026
13mm 6500027
16mm 6500028
Drill Press Vices CDV30B 6501901
CDV40B 6501902
CDV50B 6501903
CDV60B 6501904
Table Clamps CVC6 6501920
CVC9 6501925
Drill Bit Tools table DBT1 6500230
To Next Page
