7 The perfect weld - with the correct combination of arc length,
amperage regulation and inclination of the electrode you will, with
practice, produce the perfect weld. This should be regular with
uniform ripples and no slag contamination. The arc will make a
steady crackling sound.
8.0 MAINTENANCE AND SERVICING
Your CLARKE arc welder is a simple and robust unit, requiring
virtually no maintenance other than the guidelines shown below:
Keep the ventilation holes in welder clean to avoid the build up
of dirt and oxides inside the machine, this can reduce machine
output.
Check all cables periodically; they must be in a good condition
and free of cracks or cuts.
Always try to avoid getting particles of metal inside the machine
since they could cause short circuits.
Periodically clean the inside of the welder with compressed air
IMPORTANT: unplug the welder before cleaning.
Should you have a problem with your machine contact your local
service agent or CLARKE POWER PRODUCTS, Inc. at
(800)227-9603
14