Clas Ohlson TT-989E - Care and Maintenance; Cleaning the Record Player and Records; Replacing the Pickup Needle; Aligning Tonearm Auto-Stop Position

1
ENGLISH
8. Care and Maintenance
8.1 Cleaning
- Clean dusty records with a record brush.
- Always fold down the cover when the record player is not in use. This is to prevent dust from collecting on
the turntable and pickup needle.
- The record player can be cleaned with a lightly moistened cloth.
8.2 Changing the pickup needle
1. Hold the pickup needle with one hand and
push down a ne screwdriver on the front
edge between the pickup and the needle.
Carefully tilt the screwdriver backwards
according to the gure which removes the
needle.
. Attach a new needle by attaching it to the rear
edge rst. Thereafter attach it to the front edge.
8.3 Aligning the tonearm stopping position
First remove the rubber cover from the alignment screw (8).
The tonearm returns to the tonearm rest before the entire record has been played:
Using a cross headed screwdriver; turn the alignment screw (8) clockwise to adjust the tonearm stop
position closer to the centre of the record.
The tonearm does not return to the tonearm rest after the record has nished playing:
Using a cross headed screwdriver; turn the alignment screw (8) anticlockwise to adjust the tonearm stop
position further away from the centre of the record.
Remark:
The stop position may need to be adjusted to suit your record selection. The factory-set stop position is
based on the most common template.