KB-702/KB-702GM TWO-CHANNEL SPEAKER STATIONS
2-1
INSTALLATION
1. Unpack the unit and inspect for any damage that may have occurred in
shipping.
2. Set the option switches to the default (up) position.
3. Connect the intercom lines. If only one intercom line is to be connected,
turn option switch #1 to the on or closed position.
4. Install the KB-702 into the four-gang outlet box or V-box. (For additional
information, refer to the Clear-Com System Installation Manual.)
5. Set listen levels and sidetones. (Refer to the listen level and sidetone setting
topics in the Operation chapter of this manual.)
6. The speaker station should now be operating properly.
7. Read the rest of this manual for further information.
2
To Next Page
Loading...
Need help?
General
