Important:
1) The
QConnect battery is recyclable.
2) Do not dispose of the battery in a fire, as this will result in an
explosion.
13
Charging
Charging the QConnect
The QConnect has a built-in rechargeable battery and can be used for up to5-6 hours
when fully charged. Before using it for the first time, it is recommended to charge the
battery fully. When the QConnect is low on power, the red LED will flash, indicating that
it is time to charge the battery.
To charge, connect the USB cable to the QConnect and to the AC power adapter as
shown on page 10, then plug the AC power adapter into a standard power outlet or
surge protector (recommended). The red LED will be on during charging. It takes about
3 hours to fully charge the battery. Once charging is complete, the red LED will turn off.
Alternately, you can safely leave the power supply plugged into the QConnect at all
times, eliminating the need to re-charge its battery.
Note: Please do not attempt to take the battery out of the QConnect, as this may damage
the QConnect and will void your warranty.
To Next Page
Loading...