• The QConnect and the device are within 33 feet (‘in range’) of each other.
• The receiving device has also been turned on.
• Bluetooth has been enabled on the receiving device (neckloop,
streamer or headset).
Manual connection
When the QConnect is in standby mode and not connected to any devices, briefly press
the
MFB once and it will automatically connect to the last connected device, as long as
the above criteria are met.
Headset-initiated connection
In standby mode, the QConnect can also accept a connection request sent by a
Bluetooth neckloop, streamer or headset that has previously paired with the
QConnect. Pairing action is dictated by the Bluetooth neckloop, streamer or headset
and will vary depending on the neckloop, streamer or headset. With the Quattro 4.0 or
the Quattro 4.0 LITE, press the MFB once to re-connect.
Connecting
Reconnecting to Bluetooth Devices
Automatic connection
Eve
ry time you turn on the QConnect, it will automatically reconnect to the last
connected device as long as:
18
To Next Page
Loading...