Pairing
17
Pairing to Bluetooth Devices
Things to note:
• Pairing mode will last 1 minute. If no devices can be connected within that
minute, the QConnect will enter standby mode and you will need to restart the
pairing process.
• The QConnect can only be connected to to 1 Bluetooth neckloop, streamer or
headset at a time.
• The QConnect can remember up to 8 paired devices. When the number of
paired devices exceeds 8, the oldest - paired device will be replaced.
• The QConnect will pair with any Bluetooth headset whose PIN is ‘0000’,
‘1234’, ‘1111’ or ‘8888’.
• The +/- switch on the back of the transmitter should not be used unless you
plan to go an extended time without using your QConnect. For normal use, use
the MFB to turn the QConnect on and off as detailed on page 14.
• All Bluetooth-enabled devices can sometimes cause a slight delay or echo in
the sound transmission. This latency is typically about 25-50 milliseconds, less
than a quarter of a second.
To Next Page
Loading...