15
Pairing
Pairing to Bluetooth Devices
Once the QConnect is physically to a headset jack, it will need to be paired to
your Bluetooth neckloop, streamer or headset in order to wirelessly
communicate.
1. Make sure the QConnect is off using the MFB (instructions on pg 14). Again,
do
not use the + / - switch for this.
2. Keep the QConnect within 5 feet of your Bluetooth neckloop, streamer or
headset
3. Switch on your Bluetooth neckloop,streamer or headset and set it to pairing
mode. If needed, consult the receiver's user guide for instructions.
4. On the QConnect, press and hold the MFB until the blue and red LEDs flash
alternatively, indicating that the QConnect is in pairing mode.
5. The QConnect will automatically search for the Bluetooth neckloop, streamer or
headset and complete the pairing process.
6. The QConnect will flash a solid blue for 2 seconds when it becomes paired.
7. Once the two are successfully connected, the blue LED on the QConnect will
flash every 3 seconds.
Pairing to your Bluetooth headset (we recommend our QT4 or QT4L):
To Next Page
Loading...