Clek Oobr - Installing Booster Seat Without LATCH Connectors; Full Back Mode Installation (No LATCH); LATCH Connector Retraction

3433
Installing Booster Seat WITHOUT
Using LATCH Connectors
WARNING
t'"*-63&501301&3-:*/45"--0364&5)*4#0045&34&"5*/$3&"4&45)&
3*4,0'4&3*064*/+63:03%&"5)505)&$)*-%"/%05)&34*/"4)"31
TURN, SUDDEN STOP OR CRASH.
t50"70*%*/+63:5)*4#0045&34&"5.645#&*/45"--&%#:"/"%6-5
t/&7&3-&"7&5)*4#0045&34&"56/4&$63&%*/:0637&)*$-&5)*4
BOOSTER SEAT MUST REMAIN CONNECTED TO THE LATCH LOWER ANCHORS
IN THE VEHICLE OR SECURED BY THE VEHICLE’S SEAT BELT EVEN WHEN NOT
IN USE. IN A SHARP TURN, CRASH OR SUDDEN STOP, AN UNSECURED
BOOSTER SEAT CAN BE THROWN AROUND AND COULD SEVERELY INJURE
VEHICLE OCCUPANTS.
t8)&//0564*/(-"5$)$0//&$50345)&#"$,0'5)*4#0045&34&"5
#"4&.645$0/5"$55)&7&)*$-&4&"5#"$,
Installing Booster Seat in Full Back Mode
WITHOUT Using LATCH Connectors
To install Seat Back, see “Installing/Removing Seat Back”
section of this manual on page 53.
Step 1.
Select a forward-facing vehicle seating location, which has
a lap and shoulder belt.
If the vehicle seat back is adjustable, make sure the seat
back is locked in the upright position. DO NOT allow the
child to sit in booster seat while the vehicle seat is reclined,
as shown in Figure 35.
Check that LATCH Connectors are fully retracted.
To fully retract LATCH Connectors, pull and hold Recline
Handle on front of booster seat and push LATCH
Connectors into Seat Base.
Figure 35