Unpack CleverSpa
®
on
groundsheet.
Uncoil cord and RCD/GFCI
plug, located under built-in
control unit.
Screw Hose (D) on to Air Outlet (J).
Unfold the CleverSpa
®
, ensuring
sides are as upright as possible.
Unscrew outer cap from Inflation
Valve (K). Do not unscrew the
black inner valve.
Connector Locations:
Air Outlet (J), Inflation Valve (K)
and Water Outlet (L).
J
J
D
K
L
K
07
SETTING UP YOUR CLEVERSPA
®
Lay out groundsheet (A) on
a flat even surface, clear of any
sharp objects.
A
1
Remove protective plastic
from connectors.
4
Unscrew cap from Air Outlet (J).
J
7
Push the Hose (D) into
Inflation Valve (K). Plug into
mains and switch on.
K
D
10
2
5
8
3
6
9
Press ‘Inflate/Air Jets’ on control
panel to start inflation (red light
will appear).
11
12
To aid the inflation pull the sides
upright and spread out the base.
CLEVERSPA ETL US IM_FINAL.indd 7CLEVERSPA ETL US IM_FINAL.indd 7 07/01/2020 16:1707/01/2020 16:17
To Next Page
Loading...