SETTING UP YOUR CLEVERSPA
®
10
Lay groundsheet (A)
on a flat, even surface,
clear of sharp objects
Screw Hose (D)
on to Air Outlet (J)
Once inflated,
press on control panel
to stop inflation
Add Filter Protector Cover (C)
onto Filter Cartridge (B)
Fill with fresh tap water
Fully uncoil the lead & plug,
located under the
pump & heating system
Connectors: Air Outlet (J),
Inflation Valve (K)
Water Outlet (L)
Push Hose (D)
into Inflation Valve (K)
Plug into mains & switch on
Ensure caps are screwed
back on after inflation
Set desired temperature
on control panel*
Clip on Top Cover (E)
Press on control panel
to start inflation
(Light will appear)
Screw Filter Cartridge (B)
onto Filter Connector (N)
Double lock clips with
Safety Locking Keys (H).
J
K
L
D
D
K
J
DO NOT OVER INFLATE!
WITH LIGHTS - INSERT LED STRIP BEFORE
FILLING. WITH CLEVERLINK
®
- POSITION
HOT TUB FIRST
DO NOT UNSCREW INNER VALVE!
B
N
C
*PAGE 09 - SETTING TEMPERATURE
1. 2. 3.
4.
7. 8. 9.
10.
11.
12.
5. 6.
To Next Page
Loading...
