Clevo D900K - Removing the VGA Card

Disassembly
Removing the VGA Card 2 - 11
2.Disassembly
Removing the VGA Card
1. Turn off the computer, and turn it over and remove the battery (page 2 - 5).
2. Locate the VGA bay cover and remove screws - .
3. Remove the bay cover
.
4. Remove the screws - (Figure c) from the heat sink in the order indicated on the label and and disconnect
the cable from the mainboard.
5. Carefully release the VGA card from the mainboard (Figure d).
6. Lift the VGA card up off the sockets and .
Figure 7
VGA Card Removal
a. Remove the screws.
b. Remove the cover.
c. Remove the screws in
the order indicated and
disconnect the cable.
d. Release the VGA card.
e. Lift the VGA card out off
the sockets.
1 4
5
6
9
10
11 12 13
c.
b.
a.
3
2
1
4
8
7
6
d.
e.
5
9
11
10
13
12

5. VGA Bay Cover
11. VGA card
•8 Screws