Clevo D900K - Removing the Wireless LAN Module

Disassembly
Removing the Wireless LAN Module 2 - 13
2.Disassembly
Removing the Wireless LAN Module
1. Turn off the computer, and turn it over, remove the battery (page 2 - 5) and remove the keyboard (page 2 - 12).
2. Remove screws - from the keyboard shielding
.
3. Remove the keyboard shielding , the Wireless LAN Module will be visible at point .
4. Carefully disconnect cables & then gently pull the two release latches - on the sides of the module
socket.
5. The Wireless LAN Module
(Figure c) will pop-up, and you can remove it.
1 5
Figure 9
Wireless LAN
Module Removal
a. Remove the screws.
b. Remove the keyboard
shielding.
c. Disconnect the cables
and pull the release
latches.
d. Remove the WLAN
module.
Note: Make sure you
reconnect the antenna
cables to the “Main”
and “BT” socket (Fig-
ure c).
6
7
8
9 10 11
12
5
7
b.
a.
4
3
2
6
c.
1
d.
9
8
11
10
12

6. Keyboard Shielding
12. Wireless LAN Module
•5 Screws