Clevo ITAUTEC W244HUQ Series - Removing the System Memory (RAM)

Disassembly
Removing the System Memory (RAM) 2 - 11
2.Disassembly
9. Replace the bay cover and screws (make sure you reconnect the fan cable before screwing down the bay
cover).
Note that there are four - cover pins which need to be aligned with slots in the case, to insure a proper cover
fit, before screwing down the bay cover (Figure 7d).
10. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.
5
8
d.
5
6
7
8
Figure 7
RAM Module
Removal (cont’d.)
d. Properly re-insert the
bay cover pins.