Clevo ITAUTEC W244HUQ Series - Removing the Top Case Module

Disassembly
Removing the Top Case module 2 - 19
2.Disassembly
Removing the Top Case module
1. Turn off the computer, and remove the battery (page 2 - 5), remove the HHD (page 2 - 6), remove the ODD (page
2 - 8), remove the Memory (page 2 - 10) , remove Processor (page 2 - 12), remove the WLAN (page 2 - 15) and
the remove Keyboard (page 2 - 17).
2. Remove screws
- and carefully disconnect the cables - from the Top Case module ..
3. Remove screws - from the bottom of the computer and use the Eject Pin Tool to carefully push out the hinge
cover at point .
Figure 15
Top Case module
Removal
a. Remove screws and the
cables.
b. Remove screws from the
bottom of the computer
and use the Eject Pin
Tool to push out the key-
board at point .
27

6. Top Case module
•23 Screws
1
2
3
5
6
6
1
2
3
5
4
a.
7
26
27
12
13
14
15
16
24
23
22
20
21
18
19
17
26
25
9
8
7
11
10
b.
27