Clevo ITAUTEC W244HUQ Series - Page 42

Disassembly
2 - 18 Removing the Keyboard
2.Disassembly
4. Disconnect the keyboard ribbon cable from the locking collar socket (Figure 13c)
5. Carefully lift up the keyboard (Figure 13d) off the computer.
5
6
Figure 14
Keyboard Removal
(cont’d)
c. Carefully lift the key-
board up and disconnect
the keyboard ribbon ca-
ble from the locking col-
lar socket.
d. Remove the keyboard.

Re-Inserting the
Keyboard
When re-inserting the
keyboard firstly align the
four keyboard tabs at
the bottom (Figure 14d)
at the bottom of the key-
board with the slots in
the case.

6. Keyboard
4
Keyboard Tabs
5
c.
d.
6
4