CLF Poseidon - SETUP; CONTROL PANEL AND MENU NAVIGATION; DMX ADDRESS SETTING

WWW.CLF-LIGHTING.COM
9
Setup
Warning! Read “Safety Information” before installing, powering, operating the xture.
Control panel and menu navigation
The onboard control panel and backlit graphic display are used to set the xture’s DMX address, congure individual xture settings
(personality), read out data and execute service utilities. See “Onboard control menus” for a complete list of menus and commands.
Using the control buttons
• To enter the menu select [ENTER].
• Press [UP], [DOWN], [LEFT] AND [RIGHT] to scroll within a menu or adjust values.
• To enter a menu, select a function or apply a selection, press [ENTER].
• To escape a function or move back one level in the menu structure, press [LEFT].
DMX address setting
The DMX address, also known as the start channel, is the rst channel used to receive instructions from the controller. For independent
control, each xture must be assigned its to a separate channel. The DMX address can be congured by using the DMX ADDRESS menu
in the control panel. For setting the DMX address press [ENTER] before you can change the address.
• NO DMX: Display ashes and shows at ‘DMX: X‘.
• DMX: Display backlight goes o󰀨 and shows ‘DMX: V‘.
• The xture is fully RDM ready. So when you are using a RDM ready console you can address the unit and read out its complete
status. For RDM functions please refer to the ANSI/ESTA E1.20-2006 standard