Clifford MATRIX 1X - Programming: Trigger Response and FACT II; Configuring Full Trigger Response Duration; Disabling False Alarm Control Technology (FACT II); Comfort Closure and Forced Passive Arming Settings

35
© 2008 directed electronics
feature by turning the ignition key to the RUN position and
pressing the Valet
®
button the programmed number of
times. AED is disabled when the system is in Valet
®
Mode.
➤ Full trigger response
3300
or 60 seconds: This determines how
long the full triggered sequence lasts. Some states have laws
regulating how long a security system can sound before it is
considered a nuisance. If your installer is programming the
security system with the Directed Bitwriter, the full triggered
response can be programmed for any duration ranging from
1 to 180 seconds.
➤ False Alarm Control Technology Off: Please refer to the
FACT II section of this manual for a complete explanation of
how FACT II operates. If FACT II is programmed off, the se-
curity system will respond to inputs from any sensor indefi-
nitely.
➤ Comfort Closure
OOffff::
Windows will close upon locking the
vehicle.
➤ Forced Passive Arming Off : If passive arming is on and a door
is left open the system will be armed after 30-seconds.
note: Because many states have laws regulating security
systems, programming FACT II off may cause your sys-
tem to violate state laws.
note: This feature will only function if the Failsafe
®
Starter Kill relay has been installed.