Clint ODIN User Manual

BUTTONS ON ODIN.
Their functions
It is always possible to reset ODIN if any issues occur.
1. Press and hold Volume “+” and Volume “-” down
simultaneously for 3-4 seconds to perform a system reset.
2. When the LED’s turns off release the buttons. Wait until
ODIN has rebooted. ODIN will say: “No device connected”
and then – “Please reconnect your device” (See page 9 for
connecting to network).
Warning: When performing a RESET all settings will be
deleted and ODIN will return to the factory default settings.
Pressing the “ ” button will switch ODIN between single
speaker mode and MultiRoom (WHA) mode.
The rst speaker is set as MASTER and the rest will be set
as SLAVES.
Note: Read more about MultiRoom (WHA) on page 22.
Reset:
MultiRoom (WHA):
18

Clint ODIN Specifications

General

Speaker type	-
Number of drivers	2
Number of speakers	1
Audio output channels	2.0 channels
Amplifier class	D
Impedance	- Ω
Frequency range	- Hz
RMS rated power	50 W
AUX in	Yes
Bluetooth	No
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Connectivity technology	Wired & Wireless
Product type	Stereo portable speaker
Product color	Gray
Recommended usage	Universal
Audio formats supported	AAC, AAC+, AIFF, FLAC, MP3, OGG, WAV, WMA
Power source type	AC
AC adapter input voltage	100 - 240 V
Power consumption (standby)	0.5 W
MP3 bit rates	- Kbit/s
Package weight	8190 g
Quantity per pack	1 pc(s)

Weight and Dimensions

Width	350 mm
Height	570 mm
Weight	6780 g