16
3 - POSITIONING
• Insert the M8 threaded bar (not supplied) to on the
support base.
• Screw the nuts, insert the flat washer.
• Insert the antibration
• Pass the M8 threaded rods into of the support
bracket on the unit.
• Insert the flat washer
• Screw the nut
• Do not over tighten the nuts, the springs, because if
too much crushed they don’t absorb vibrations
FLOOR INSTALLATION
a) nut
b) flat washer
c) bracket
d) antivibration foot
e) flat washer
f) nut
g) nut
h) A threaded bar
Perfomer by customer
For floor positioning or installation not in false ceiling the
unit provided with sheet metal cover.
To Next Page
Loading...
