20
3 - POSITIONING
Buckling
position
Straight head
screwdriver
Back cover
Front cover
Screw hole installed on the wall,use
three GB950-86 M4X20
Screw hole fixed on the wall,use one
GB950-86 M4X20
A - Screw hole installed on 86 Electri-
cian box, use two M4X25 GB823-88
Back cover
Signal
switching
wires
Cutting place of left
down side wire outlet
Left down side
wire outlet
Wiring hole
Wall hole and wiring hole
Diameter 8--10
After adjusting the front cover and then buckle the front
cover; avoid clamping the communication switching wire
during installation.
Sensor can not be
affected with damp.
A
Electrician box
B
C
B
C
B -Trap
C - Putty
C
B
Avoid the water enter into the
wired remote controller, use trap
and putty to seal the connectors
of wires during wiring installation.
To Next Page
Loading...
