EasyManuals Logo

CLIVET ELFORoom2 003.0 Installation And Maintenance Manual

CLIVET ELFORoom2 003.0
Go to English
316 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #89 background imageLoading...
Page #89 background image
THE UNIT MUST ALWAYS BE SENT TO AUTHORISED
CENTRES FOR DISMANTLING AND DISPOSAL.
When dismantling the unit, the fan, the motor and the coil, if
operating, may be recovered by the specialist centres for
reuse.
All the materials must be recovered or disposed of in
compliance with the corresponding national standards in
force.
For further information on the decommissioning of the unit,
contact the manufacturer.
10.1 DISCONNECTING
Only authorised personnel must disconnect the unit.
Avoid leak or spills into the environment .
Before disconnecting the unit, the following must be
recovered, if present:
refrigerant gas
Anti-freeze solutions in the hydraulic circuit
Awaiting dismantling and disposal, the unit can also be
stored outdoors, as bad weather and rapid changes in
temperature will not cause damage to the environment, if
electric, cooling and hydraulic circuits of the unit are
integral and closed.
The manufacturer is registered on the EEE National Register,
in compliance with implementation of Directive 2012/19/EU
and relevant national regulations on waste electrical and
electronic equipment.
This Directive requires electrical and electronic equipment to
be disposed of properly.
Equipment bearing the crossed-out wheelie bin mark must be
disposed of separately at the end of its life cycle to prevent
damage to human health and to the environment.
Electrical and electronic equipment must be disposed of
together with all of its parts.
To dispose of “household” electrical and electronic equipment,
the manufacturer recommends you contact an authorised
dealer or an authorised ecological area.
“Professional” electrical and electronic equipment must be
disposed of by authorised personnel through established
waste disposal authorities around the country.
In this regard, here is the definition of household WEEE and
professional WEEE:
WEEE from private households: WEEE originating from
private households and WEEE which comes from commercial,
industrial, institutional and other sources which, because of its
nature and quantity, is similar to that from private households.
Subject to the nature and quantity, where the waste from EEE
10 - DECOMMISSIONING
10.3 EC WEEE DIRECTIVE
10.2 DISMANTLING AND DISPOAL
was likely to have been by both a private household and users
of other than private households, it will be classed as private
household WEEE;
Professional WEEE: all WEEE which comes from users other
than private households.
This equipment may contain:
refrigerant gas, the entire contents of which must be
recovered in suitable containers by specialised personnel
with the necessary qualifications;
lubrication oil contained in compressors and in the cooling
circuit to be collected;
mixtures with antifreeze in the water circuit, the contents of
which are to be collected;
mechanical and electrical parts to be separated and
disposed of as authorised.
When machine components to be replaced for maintenance
purposes are removed or when the entire unit reaches the
end of its life and needs to be removed from the installation,
waste should be separated by its nature and disposed of by
authorised personnel at existing collection centres.
89

Other manuals for CLIVET ELFORoom2 003.0

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CLIVET ELFORoom2 003.0 and is the answer not in the manual?

CLIVET ELFORoom2 003.0 Specifications

General IconGeneral
BrandCLIVET
ModelELFORoom2 003.0
CategoryTouch terminals
LanguageEnglish

Related product manuals