What to do if P1 error appears on CLIVET Heat Pump?
If the P1 protection intervenes 10 times in 150 minutes, turn the power off to reset the CLIVET Heat Pump. If there is a remote control, turn the power off to reset it. Note that at start-up, the low pressure switch is bypassed for 3 minutes.
What to do if E9 error appears on CLIVET WSAN-XES 18.2 Heat Pump?
If the protection intervenes 3 times in 60 minutes, turn the power off to reset the CLIVET Heat Pump.
What to do if PL error appears on CLIVET Heat Pump?
If the PL protection intervenes 3 times in 100 minutes, turn the power off to reset the CLIVET Heat Pump.
What to do if PE error appears on CLIVET WSAN-XES 18.2?
If the PE protection intervenes 3 times in 60 minutes, turn the power off to reset the CLIVET Heat Pump. Also, check that probe Two is correctly positioned.
What to do if P9 error appears on CLIVET WSAN-XES 18.2 Heat Pump?
If the P9 protection intervenes 3 times in 60 minutes, turn the power off to reset the CLIVET Heat Pump.
How to fix E1 error on CLIVET WSAN-XES 18.2 Heat Pump?
To resolve the E1 error on your CLIVET Heat Pump, ensure that the three phases are present at the same time and offset by 120°. Restoring the power supply clears the error. Note that the power supply is checked only in the initial switch-on phase and not during operation.
What to do if E3 error appears on CLIVET Heat Pump?
When the number of units in line is 2 or more, check if the Tw sensor of your CLIVET Heat Pump is faulty or is not required. When the number of units in line is 1, Tw = Two by default.
To Next Page
General