M01W45H6-06
WSAT-SC
75C-180F
- GENERAL -
6
ACCESSORIES
- copper / aluminium condenser coils with acrylic lining
- copper / aluminium condenser coils with Fin Guard (Silver) treatment
- steel mesh strainer to be mounted at the exchanger inlet. (The manufacturer declines all liability with invalidation of the
guarantee if it is not installed inside the system).
- condenser coil and compressor compartment protection grill.
- Anti-hail protection grilles
- compressor suction shut-off valve
- R-22
- Hydro Pack
- Anti-ice electric heaters utility side for hydronic group
- phase monitor
- power factor correction capacitors (cosfi > 0.9)
- Free contacts for compressor state
- Master-Slave function
- ECOBreeze
- set point compensation with outside temperature probe
- set point compensation with 4-20 mA signal
- set point compensation according to the outside enthalpy
- high and low pressure gauges
- remote microprocessor control unit
- data logger (device for the acquisition of status and regulation values, as well as for recording the operation conditions
in the surrounding of alarm events)
- spring antivibration mounts
- CAN/LON WORKS serial converter kit
- CAN/MODBUS serial converter kit
TEST
All the units are factory-tested in specific steps, before shipping them. After the approval, the moisture contents present
in all circuits are analyzed, in order to ensure the respect of the limits set by the manufacturers of the different
components.
CONFIGURATION CODE
( 1 ) ( 2 ) ( 3 ) ( 4 ) ( 5 ) ( 6 )
WSAT-SC D B FC 65D EN T C
- (St andard) - (St andard) - (St andard) SC (St andard) T
(St andard) CE
(St andard)
RBFCD EN C
D
(1) ENERGY RECOVERY
Total Recovery ( R)
size 75C-90C NOT AVAILABLE
performed using braze-welded plate exchangers suitable for
recovering 100% of the condensing heat for the production
of hot water In addition, exchangers are complete with safety
differential pressure switch on the water side, antifreeze
heater to protect against the risk of ice.
Partial Recovery (D)
size 75C-90C NOT AVAILABLE
Performed using braze-welded plate exchangers suitable for
recovering the desuperheating heat, up to a maximum of
20% of the total heat of the unit. In addition, exchangers are
complete with antifreeze heater to protect against
the risk of ice.
Not required (-)
(2) LOW TEMPERATURE
Low water temperature (B)
this version allows unit operation in the range of water and
glycol mix tempera-tures between +5°C and -8°C.
Two versions are available
- Unit for low temperatures only
- Unit with double working set point
(For special conditions contact our sales office)
(3) ENERGY SAVINGS
Direct free-cooling (FCD)
Version that allows to recovery free-cooling from ambient
when tha ambient air temperature is lower than the
system outlet water temperature.
size 75C-90C NOT AVAILABLE
(4) ACOUSTIC CONFIGURATION
compressors soundproofing (SC)
this configuration is obtained by inserting the compressors
in a soundproof enclosure.
Extremely low noise (EN)
this configuration is achieved by further soundproofing the
compressor compartment and reducing the speed of the
fans, with a larger condensing section.
(5) ENERGY EFFICIENCY
Temperate Climate (T)
standard
(6) HEAT EXCHANGERS APPROVALS
C = CLIVET (Internal testing)
CE = PED (European testing)
To Next Page
Loading...
Need help?
General