In Main UI, choose “configuration”GPI/O configuration GPI configuration”, pop up dialog box as per
picture 4‐18. Choose triggering conditions and click “configuration” for confirmation.
Pic 4‐14 GPI configuration
Inquiry: inquiry each port triggering parameters.
Configuration: choose the port to be set and then click “configuration” for confirmation.
Triggering start condition: choose the mode from pull‐down list.
Triggering execution command: choose the mode from pull‐down list.
Triggering stop condition: choose the mode from pull‐down list.
Remarks: when triggering conditions are satisfied, reader will execute configured command.
GPO configuration
In main UI, choose “ configuration” “GPI/O configuration” “GPO configuration”, pop up dialog box as
per picture 4‐20.
Picture 4‐15 GPO configuration
To Next Page
Loading...