ELECTRICAL
CONNECTION
CMA-44
REAR VIEW
1-2008
CMA-44/66
Quick Setup
Instructions
3
PRESSURE
REGULATOR
OPTIONAL VENT
HOODS 4"X16"
2
STEP
1
STEP
3
STEP
VOLTS PHASE AMPS
208 1 61
240 1 65
208 3 38
240 3 42
HEATER 10kW
ELECTRICAL
HARD WIRE
CONNECTION
POINT
3/4" WATER
INLET
2
1/2" WATER
INLET
1
1
DRAIN PIPE
4
DETERGENT
FITTING INLET
5
MIXING
CHAMBER
5
SCRAP
TRAP DRAIN
4
Connect hot water supply line to rinse 1/2"water
i n l e t . Adjust pressure regulator if necessary. Water
temperature should be 140° F wash and 140° F rinse
for CMA-44L. The CMA-44H should read 155° F wash,
180° F rinse.
Connect fill water supply line (120° F/140° F) to a
3 / 4 " w a t e r i n l e t t o f i l l t h e m a c h i n e .
C onnec t d r a in at e i t h er en d o f the h o r i z o ntal
d rain p i p e from w a s h tank o r s c rap trap drain.
3 Phase: Connect the wire with the highest voltage
(stinger lead) to L2 on the contactor. L1, L2 and L3
must comply with all local and state electrical codes
for sizing of wire and circuit breaker protection.
Additional information can be found in the Installation
and Operation manual supplied with machine.
DRAIN PLUMBING
NOT SUPPLIED
2" HOLE
PLUG
Remove plastic plug to install detergent fitting. Remove
plug from the mixing chamber to install sani/rinse injection
fitting (sanitizer detergent and rinse injection fittings provided
by dispenser manufacturer, CMA does not supply.)
WARNIN G : Electrical and plumbing
connections need to be made by a
licensed service person and comply
with all Federal, State and Local
Health, Electrical, Plumbing and
Safety codes.
800-854-6417
2" HOLE
PLUG
4
STEP
5
STEP
PLUGS
REMOVE
PLASTIC
PLUG AND
INSTALL
DETERGENT
FITTING
To Next Page
Need help?
General
