CMC NV – Airmaster Q1 Installation Guide – V1.0 – MANY1032A.EN
Page 4
Section 1: Situation of the product
The controller is an industrial controller.
This hardware installation guide is a guide for the
hardware related items. Refer to the software
specifications file for information on how to work with the
unit.
The application area is restricted to components used in
machines that comply with the European machine EMC
directive EMC 2014/30/EU and LVD 2014/35/EU. The
application area is located in electrical driven compressors
and dryers in an industrial environment. Please contact
CMC for appliance in other machines.
The controller does not need to comply to the European
Pressure Equipment Directive 2014/68/EU, because no
parts are under pressure, and the controller is not a safety
component.
The controller is a component, which can’t operate without
other components. However, it is not a safety component,
and it is not a machine.
The controller is to be used in a standard industrial
environment.
The controller may only be used in places without an
explosion risk. So it may never be used where explosion-
proof equipment is required.
This controller may not be used for maritime purposes. It
may also not be used in any way as part of an assembly
that could be used for military or terrorist use.
The controller without additional protection is to be used in
areas of pollution degree 1 or 2. Of course the user can
add additional protection for higher pollution degrees.
The installation of the controller must be made in
accordance with the applicable national and international
standards and regulations.
To Next Page
Loading...
Need help?
General
