Step 1: Lift each of the four corners up to release the velcro seal.
Step 2: Remove bottom half of velcro on new top and place on top of cart. Press each corner down to seal.
800.338.23724 www.cmecorp.com
Replace Top Worksurface (Key lock only)
Step 1: Use a #3 philips drive to remove four screws from caster. Please note that one for the screws is different
(shown circled) Always note the location of the different (Sheetmetal style) screw.
Step 2: Hold new caster up and use same screws to re-install.
Replace Casters
To Next Page
Loading...
Need help?
General