5 – Installation and Set Up
5 – Installation and Set Up
Unpacking
1. Remove the T34L
TM
Syringe Pump & accessories from the packaging and inspect for damage during
shipment or storage.
Warning: Do not use T34L
TM
if there are any obvious signs of damage. Return for inspection
by authorized service personnel.
2. Make sure you have the following items:
T34L
TM
Syringe Pump
Operation Manual
Carry Pouch (Optional)
Lockbox (Optional)
External Charger
Pole mounting unit (Optional)
If any items are missing or damaged, contact your supplies department to order replacement.
Power Supply and Charging the Pump
The T34L
TM
pump includes a Li-Polymer battery which enables operation when the patient is ambulatory,
being moved, or even during electrical power failures. Fully charged, the battery provides 15-17 hours of
operation at an infusion rate of 125 ml/h.
Wall Charger
To charge the battery, connect the charger plug to mains power supply and to the pump DC connector on
the rear of the pump. Note that the DC connector must be inserted directly in the correct way.
NOTE: After the “End Battery“ signal has been activated or following long periods of storage,
wait 2 minutes after the pump has been connected to an AC power supply before operating.
Caution: Leaving the battery in an uncharged state for a long period of time may damage the
battery.
Caution: do not twist the DC connector while disconnecting from the rear of the pump.
NOTE: Whenever possible, use the pump connected to an AC power supply. This preserves
the battery power supply for emergency use or for situations where the AC power is not
available.
To Next Page
Loading...
Need help?
General
