6.1.2 Connecting Hardware
Zero-3 Control
CncPod
The LPT 1 connector is connected to the LPT 1 of the Zero-3 controller.
The LPT 2 connector is only required with the corresponding accessories and is then also connected
to the Zero-3 controller.
The CncPod is connected to the PC via a network cable. If the simultaneous use of the Internet /
network is desired or required, a LAN switch can be used.
Art.No.: 400161 Network Switch 5-port 10/100 Mbit/s + Lan cable 1m
The power supply is via a mini USB cable. This can be connected directly to a USB port of the PC
or even better to a USB power supply.
To Next Page
Loading...
