CNC-Step High-Z Series - 3 Connecting the Machine to the Zero-3 Control

Quick Start Guide
High-Z Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 8
Support: +49 (0)2831/91021-50
27.09.2013
3 Connecting the machine to the Zero-3 control
- Make sure that the control is turned off.
- Connect all 5 cables with the Zero-3 controller.
- Make sure that you back up all connections with the knurled screws from loosening.
Zero-3 Front Side
Connection cable of the machine