CONTENTS
1 CONNECTORS AND CABLES ON THE MACHINE..................................................... 5
2 CONNECTIONS TO OF THE ZERO-3 STEPPER MOTOR CONTROLLER ................ 6
2.1 Front side .................................................................................................................................. 6
2.2 Back side .................................................................................................................................... 7
3 CONNECTING THE MACHINE TO THE ZERO-3 CONTROL ...................................... 8
4 CONNECTION POSSIBILITY OF A 4TH AXIS ............................................................. 9
5 CONNECTION OPTIONS OF OPTIONAL ACCESSORIES ....................................... 10
5.1 Overview Connection and power supply via Zero-3 control .............................................. 10
5.2 Milling motors ........................................................................................................................ 11
5.3 Noga spray cooling with solenoid valve ................................................................................ 11
5.4 Inverter and HF spindles ....................................................................................................... 12
5.5 Granitograv and laser engraving unit .................................................................................. 12
6 SOFTWARE INSTALLATION ..................................................................................... 13
6.1 KinetiC-NC ............................................................................................................................. 13
6.1.1 CncPod............................................................................................................................... 13
6.1.2 Connecting Hardware ........................................................................................................ 14
6.2 WinPCNC ............................................................................................................................... 15
6.2.1 Installation ......................................................................................................................... 16
6.2.2 Connecting the computer to the Zero-3 control ................................................................. 16
6.2.3 Configuration ..................................................................................................................... 17
6.2.4 Determination of the LPT interface (Light and Economy) ............................................... 17
6.2.5 Determination of the COM interface (Professional) ......................................................... 19
6.2.6 Entry of the determined interface / port address in WinPCNC ......................................... 20
6.2.7 Entry LPT2 port (only Economy) ...................................................................................... 20
6.2.8 check the efficiency ........................................................................................................... 21
6.3 ConstruCam 3D ...................................................................................................................... 22
6.3.1 Installation ......................................................................................................................... 22
6.3.2 Milling program generation with KinetiC-NC .................................................................. 22
6.3.3 Interaction with WinPC-NC .............................................................................................. 23
6.4 Other Software ....................................................................................................................... 23
To Next Page
Loading...
