Need help?Do you have a question about the CNC4PC C10 and is the answer not in the manual?
Explains the use of the 5VDC enable signal for controlling card operation and output status.
Configures input voltage for pins 2-9 via a 4.7Kohm resistor for pull-up or pull-down.
Diagrams for wiring NPN open collector proximity sensors (normally open/closed).
Guidance on calculating the R1 resistor value for NPN sensors with internal pull-up resistors.
Wiring diagrams for connecting PNP open collector proximity sensors (normally open/closed).
General| Brand | CNC4PC |
|---|---|
| Model | C10 |
| Category | Recording Equipment |
| Language | English |
To Next Page