CO/Tech MDDG-20DEN7-QA3 User Manual

12
ENGLISH
• If thedehumidifier is switched off after thetimer settings have been made, thesettings will be
deleted.
• If thewater reservoir fills up (“P2” appears on thedisplay) while thedehumidifier is operating
and before theset timer time has been reached, thetimer setting will be deleted.
When thedehumidifier is switched off:
1. Press [ Timer ], thestart timer indicator lights up.
2. Set thedesired start time by pressing or holding down [ − ] or [ + ]. Each press changes thetime
in 30-min increments up to the10-hour mark. Thereafter in increments of 60 minutes.
3. Press [ Timer ] again, thestop timer indicator lights up.
4. Set thedesired stop time by pressing or holding down [ − ] or [ + ].
5. After afew seconds thedisplay reverts to showing thecurrent humidity and thetimer
indicators light up to show that thetimer settings are activated.
6. The [ Timer ] button can be pressed at any time to check thesettings.
7. Thetimer settings can be changed at any time by pressing [ Timer ] and then [ − ] or [ + ].
• If thedehumidifier is switched on after thetimer settings have been made, thesettings will be deleted.
• If thewater reservoir fills up (“P2” appears on thedisplay) while thedehumidifier is operating
and before theset timer time has been reached, thetimer setting will be deleted.
Automatic shut-o
• When thewater reservoir becomes full during normal use, thedehumidifier’s compressor
shuts off automatically.
• Thefan continues for another 30 seconds to dry theinside of thedehumidifier.
• Thedehumidifier beeps 8 times, the“Water Full” LED indicator flashes and “P2” appears on
thedisplay.
Emptying the water reservoir
1. Unplug themains lead from thewall socket.
2. Grip thewater reservoir by thehandles (one
on each side) and pull it forwards.
3. Empty thewater out of water reservoir
and then refit it onto thedehumidifier.
Thedehumidifier will restart automatically once
thewater reservoir has been refitted if it was
shut off automatically.
Automatic defrost feature
• Thedehumidifier is equipped with anautomatic defrost feature. Frost can build up on some
components inside thedehumidifier under certain conditions. Thedefrost feature removes
this frost.
• Thedehumidifier’s compressor will shut off when thedefrost feature is activated and thefan
continues to run until thefrost has disappeared.
• Apurling sound might be heard from thedehumidifier during defrosting, this is normal.
• No settings can or need to be made for this feature.

CO/Tech MDDG-20DEN7-QA3 Specifications

General

Brand	CO/Tech
Model	MDDG-20DEN7-QA3
Category	Dehumidifier
Language	English