10
interval+space+static time interval” to the tracker device.
6.6.2 For example: send SMS “ITV123456 10 500” it will report data to server
at 10s time interval when vehicle is moving; 500s time interval when
vehicle is static.
6.7 Cell ID Tracking
6.7.1 You must set up the APN of your local GSM network for the SIM card in
tracker first before using this function, if there is user name and password for
GPRS login, Please refer to following to configure the APN, user name and
password for GPRS login.
6.7.2 After configure the APN, send SMS “cell+password” to device, it will
reply SMS with nearest GSM tower cell ID info.
6.7.3 LBS data upload to server: Under normal circumstances, the device is
reported last valid location data to server when devices can’t receive GPS signal,
when you need to located base station,
Set command: "LBS+password+space+1" to enable the function, the LBS
tracking data will transmit to platform server \.
SMS command to deactivate: "LBS + password +space+0".
6.8 Modes switch between “track” & “monitor”
6.8.1 The default mode is “track” (track mode).
6.8.2 Send SMS command "monitor+password" to tracker device of vehicle
terminal, it will reply "MONITOR,CONFIG OK" and switch to “monitor”
mode. In this mode, the user can dial up the tracker device to monitor the voice.
To Next Page
Loading...
