COBAN GROUP TK103A - Overspeed Alarm; ACC Working Alarm; Vibration Alarm (TK103 B Optional )

13
6.10.5 Overspeed alarm
6.10.5.1 Set up: Send SMS “speed+password+space+80” to the unit(suppose
the speed is 80km/h),and it will reply “speed OK!”. When the target moves
exceeding 80km/h.the unit will send SMS “speed+Geo-info” to the central
number.
6.10.5.2 Cancel: Send SMS “speed+password+space+0” to deactivate the
overspeed alarm.
Remark: It is recommended that the speed alarm is set at not less than
30km/h.For below that rate; it may cause the excursion of the GPS signal
influenced by clouds etc.
6.10.6 ACC working alarm
6.10.6.1 This function is disabled as default. To active this functions, send
"ACC+password+Space+1" to tracker, it will reply "ACC,CONFIG OK". And
tracker will send "ACC on+latitude & longitude" to central number when detect
ignition action, that means the vehicle has been started.
6.10.6.2 Send "ACC+password+Space+0" to disabled this function, tracker
will reply "ACC,CONFIG OK".
6.10.7 Vibration alarm (TK103B optional )
Send SMS “vibrate+password+space+0” to deactivate this function.
Send SMS “vibrate+password+space+1-3” to set up vibrate level from 1 to 3
(1 is strongest level, 3 is lowest level)