Section 1 - General Information
1.9 RECOMMENDED ANTENNAS
The following is list of recommended Wulfsberg antennas for the CVC-151. The installer is responsible for
determining if these antennas are appropriate for the given installation.
Table 1-8 CVC-151 Recommended Antennas
1.10 TOOLS REQUIRED BUT NOT SUPPLIED
A special crimping tool, positioner and an insertion/extraction tool are needed when the
CVC-151 is installed. These tools and their part numbers (P/N) are listed below.
INSERTION/EXTRACTION TOOL
1.11 LICENSE REQUIREMENTS
Check in the country of operation with the governing body for any licensing requirements. The end user is
responsible for obtaining any required licenses.
This equipment has been type accepted by the FCC under type acceptance number FRWCVC-151.
1.12 Instruction for Continued Airworthiness
There is no periodic maintenance for this article. Maintenance and/or repair is only upon failure.
1.13 CERTIFICATION CONSIDERATIONS
The conditions and test for TSO approval of this article are minimum performance standards. It is the responsibility
of those desiring to install this article either on or within a specific type or class of aircraft to determine that the
aircraft installation conditions are within the TSO standards. The article may be installed only if further evaluation by
the applicant, i.e. user/installer, documents an acceptable installation and is approved by the Administrator.
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
Need help?
General
