Section 1 - General Information
1.14 FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Part 15.21
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user’s authority to operate the
equipment.
1.15 ESDS Device Labels and Symbols
Caution: This equipment contains electrostatic discharge sensitive (ESDS) devices. All modules containing
ESDS devices are flagged or identified on schematics and assembly illustrations, and are
individually identified in the parts list. All ESDS devices must be handled in accordance with
procedures outlined in the "repair" section of this manual.
ESDS devices include, but are not limited to, C-MOS, J-MOS, PMOS, NMOS, SOCMOS, HMOS,
MOS/FET, microwave mixer diodes, some bipolar devices, and some metal film resistors.
The labels and symbols shown in Figure 1 are used by Wulfsberg to identify ESDS applications. The labels DO
NOT appear on units and modules manufactured prior to the adoption of the STANDARD symbol.
Identifies ESDS device is present and need for
special handling exists.
Figure 1. Electrostatic Discharge Sensitive (ESDS) Device Labels and Symbols
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
Need help?
General
