Chapter 4: Using the Terminal Control Unit
36 Configuration
Per default the password is empty.
To change the password type:
password sysadm, then enter and confirm the new password.
5. Type the commands for Terminal Control Unit or SAILOR 3027.
To list all commands
For a list of all commands for the Terminal Control Unit, type:
tt6194:/$ help
The commands for the currently selected user mode (normal or sysadm)
are listed.
To auto-connect to the SAILOR 3027
To connect directly to a SAILOR 3027 after start-up of the Terminal Control
Unit, do as follows:
1. Connect a computer to the RS-232 interface or the LAN interface of the
TCU and start a terminal program as described in the section Using
commands.
2. Log in as a system administrator:
tt6194:/$ su sysadm
Enter password:
3. To enable auto connect to the SAILOR 3027, type:
tt6194:/$ auto_minic 1
Automatic Mini-C prompt is enabled
(reboot required)
4. To reboot the Terminal Control Unit, type:
tt6194:/$ reboot
<Your 'TELNET' connection has terminated>
can0:/$
You are now connected to the SAILOR 3027.
To Next Page