Chapter 2: Operation
18 DSC calls
scanning stops, the radio is tuned into the displayed channel and
transmission starts immediately on the displayed working channel.
To start scanning press the soft key
SCAN. The SCAN menu is shown. Press
START to start scanning. To leave the SCAN
menu, but not the scanning procedure, press
EXIT.
To stop scanning press STOP, QUIT if not
in the SCAN menu, or press PTT on the
speaking device.
To tag a channel for scanning turn the
selector knob until the wanted channel is in
the display. Then press the soft key TAG.
The display shows the channel number and
the word TAG at the right side of the display.
To remove a channel from the
scanning sequence turn the selector knob until the tagged channel is
displayed. Then press the soft key TAG to remove the tag.
To see only tagged channels press the soft key FILTER and turn the
selector knob. Press the soft key FILTER to leave the FILTER function. For
details how to set up the scanning function see Radio setup on page 37.
DSC calls
In this section of the manual you find information on:
• Sending, acknowledging and cancelling own distress
• DROBOSE — Distress Relay on behalf of someone else
• Receiving distress calls
• DSC calls for communication
Note
The displayed working channel is temporarily included in the
scanning list (although no TAG icon is shown).
EXIT
START
TAG
FILTER
INT
INTERSHIP/PORT
EXIT
STOP
TAG
FILTER
MMSI:123456789
INT
SCANNING[16]
N 12°34.5678
E 123°45.6789
22:07
GPS
MMSI:123456789
N 12°34.5678
E 123°45.6789
22:07
GPS
To Next Page
Loading...
