9
Chapter 2
22222
Operation
Operation 2
This chapter has the following sections:
• To get started
• Settings
• To work with messages
• Alerts and notifications
To get started
As soon as DC power is provided the SAILOR 6282 AIS Transponder is on.
To switch on the SAILOR 6004 Control Panel push the power
button. Operate the SAILOR 6004 Control Panel by tapping the
touch screen. To switch off the SAILOR 6004 Control Panel
push and hold the power button for 2 seconds and follow the
instructions on the screen.
The AIS application has been installed during the installation of the SAILOR
6280/6281 AIS System. To start the AIS application tap the AIS icon in the
display of the SAILOR 6004 Control Panel.
Note
When the remote switch in the SAILOR 6004 Control Panel is
wired and it is switched on, you can only use the Power button to
reboot the SAILOR 6004 Control Panel, you cannot switch it off.
Figure 7: Screen after start-up (example)
To Next Page
