Chapter 2: Operation
38 Alerts and notifications
Alerts and notifications
Alert management is handled by the Control Panel. Note that the following
description is a general description of alerts and notification.
Introduction to alerts and notifications
Alerts are reported and indicated by icons in the bottom bar of the SAILOR
6004 Control Panel display. An alert is presented together with its alert text.
An alert can be of the type alarm, warning or caution. If an alarm is not
acknowledged the audible alarm signal (3 beeps) is repeated every seventh
second until it is acknowledged. If a warning is not acknowledged the
audible warning signal (2 beeps) is repeated every minute until it is
acknowledged. The audible warning signal also disappears if the condition is
rectified.
The alert list is prioritized. The most important alert is an alarm, then
warning and finally caution. The most important active alerts move to the
top of the list, after that the alerts with the same importance are sorted by
activation time.
You can display the current list of active, unacknowledged alerts and
notifications by tapping the lower right corner of the SAILOR 6004 Control
Panel display where the alert indication and UTC time is displayed.
Note
The AIS Receiver reports alerts of the type warning or caution.
To Next Page
Loading...
