5
Chapter 1 Product Overview
1.1 Rear Panel
NO Physical interface Connection
1 HDMI port HDMI high-definition port.
2 WAN port Router network input port/camera-connecting port
3 USB port 1
Connect with USB mouse or plug in a USB flash disk for
backup.
4 USB port 2 Insert a USB flash disk as a redundant hard disk for recording.
5 Power port Connect with the power supply DC12V 2A.
6 Reset button
Press three seconds for password reset. Press ten seconds for
factory reset.
7 SD card port
Plug in SD card as a hard disk to record. (When the hard disk is
working, the SD card is not working)
Note
Antenna (Inside the NVR
structure)
It is used to transmit and receive wireless signals, so that the
NVR and the camera can communicate well.
To Next Page
Loading...
