Cobra AK4169 - Using the Cobra Vehicle Finder; Interpreting Cobra Alarm Memory

12
3.5. Vehicle finder
This feature is enabled by default and can be disabled by your Cobra or Toyota dealer.
Vehicle finder enables the user to manually flash the hazard lights 4 times to help locate
the vehicle when the system is in the fully armed state.
To activate vehicle finder, proceed as follows:
Activation steps
Hazard light
indication
Alarm status light (LED)
1
Lock the vehicle
using the remote
control
Flashes once
ON for 30 seconds
2
After 30 second
-
LED flashes (at a steady rate)
3
Press remote
control lock button
once
Flashes 4 times
LED flashes (at a steady rate)
3.6. Alarm memory
If the alarm went off during your absence, the hazard lights will flash 5 times when the
doors are unlocked and the system will chirp 5 times.
The system memorises the last alarm trigger. This can then be identified by counting the
number of flashes of the alarm LED before switching the ignition ON.
1 flash: Doors
2 flashes: Intrusion (ultrasonic) sensor
3 flashes: Bonnet
4 flashes: Ignition switch (hot wire)
5 flashes: Boot / Side doors
6 flashes: Alarm system wiring or siren
7 flashes: Optional sensor
Note:
- There is a pause of 2 seconds between 2 different alarm memories.
Important:
- If you suspect that the alarm system is sounding due to false alarms, please count the
number of LED flashes and contact your Cobra or Toyota dealer.