Cobra Bridge compact alarm User Manual

R
R
GB
GB
FUNCTIONAL TEST OF THE
INSTALLATION AND SENSOR
REGULATION
Carry out the test operations in the
indicated sequence after having
shut the doors, bonnet and boot.
The test operations must be carried
out within the 40 second inhibition
phase. An alarm status will be
generated (siren and blinker) once
this time has elapsed.
A
B
Arm the alarm by pressing A
Make sure that there is nothing able to
move in the passenger compartment.
Shut the doors, bonnet and boot, keeping
2 windows on the same side lowered about
10 centimeters.
Insert a hand into the vehicle and wave it
about on a level with the front seat headrest.
If the LED starts blinking quickly the sensor
is working properly
Disarm the alarm by pressing A and close
the windows.
Arm the alarm by pressing A and hit the
windows with the fist.The LED has to go
on blinking in the same way.
ONLY FOR
7903 - 7913
7908 - 7918
A
B
FUNCTIONAL TEST OF THE VOLTAGE
DROP SENSOR
Carry out the test operations in the
indicated sequence after having shut
the doors, bonnet and boot.
The test operations must be carried
out after the 40 second inhibition
phase.
TEST TO BE CONDUCTED BEFORE TO CONNECT
THE BLUE WIRE
Arm the alarm by pressing button A
on the remote control. The turn
indicators will blink twice. The buzzer
will beep twice (if activated).
The door lock.
The LED blinks.
Wait 40 seconds and then open the
boot. The interior light will go on
An alarm has to occur (siren sounding)
Disarm the alarm by pressing A
on the radio control
A
B
A
B
FOR ALL VERSIONS
56 57

Cobra Bridge compact alarm Specifications

General

Brand	Cobra
Model	Bridge compact alarm
Category	Car Alarm
Language	English