Cobra MicroTalk - Initiate Calls and Communicate

Push and release button.The indicator
icon will flash and the icon will remain on
for 3 seconds.The unit you are calling will hear
a 2 second ring tone.
Turn on your MicroTalk 2-way radio.
An audible “tone”will indicate the unit is on.
The LCD will go through a 3 second self test
and then to operational mode.
Note
Both the calling and re ce i v -
ing units must be on same
channel and subchannel fo r
the call function to wo r k .
Note
Your incoming “Ca l l ”a u d i o
ringing level is dependent on
your unit’s volume setting.
Operation
11
Operation
10
Select desired channel by pushing and
releasing buttons.
3
4
Wait for the party’s response or proceed to
“Talking To Another Party”section on next
page.
5
1
Calling
Another
Party
Calling Another Party
To alert another party that you wish to
communicate:
Place antenna in full
upright position.
2
310WX.MANUAL.qx copy 6/17/99 12:18 PM Page 10