POWERING ON THE DEVICE
The device will power on automatically when plugged in and can also be powered by PRESSING AND
HOLDING the Multifunction button until the display activates (when connected to power).
LOOP RECORDINGS
Once the MicroSD card is full, the camera will continuously overwrite the oldest footage recorded with
recent recordings. To protect a clip so that it will not be overwritten, press the Multifunction button so
that the clip is moved into the locked content partition.
EMERGENCY RECORDINGS
An Emergency Recording is triggered when the Multifunction button is pressed or when the G-Sensor
registers a significant impact (hard braking or collision). Emergency Recordings create locked files
that are not overwritten by Continuous Loop Recording. To ensure that important footage is not lost
surrounding an incident, the prior video clip is locked if the incident happens within 30 seconds of the
beginning or end of a clip.
THE MicroSD MEMORY CARD
The device comes with a MicroSD memory card. To remove the MicroSD card, press firmly on the
MicroSD card to push it further into the slot. There will be a click and the MicroSD card will pop out on
release. Extract the card and replace as necessary by inserting a card into the slot and pressing until it
locks in place. This camera is compatible with MicroSD cards up to 128GB. Please be sure to format the
card in-camera before use. Class 10 high-endurance cards from reputable brands are recommended for
constant video recording of a dash camera.
NAVIGATING MENUS
When in a menu, press or to navigate to the menu item you want to select or change and then
press to select or change the option associated with that item. Pressing at any time will exit the
menu without saving changes.
VOLUME ADJUST
Models with LCD displays allow the user to select “Volume” in the setting menu to and adjust volume of
notifications and voice announcements. Both products with LCD displays and without allow for volume
adjustment using the Drive Smarter App.
Installation
7 8
MOUNT
To install the Adhesive Windshield Mount, slide the dash cam onto the mount. Remove protective
film from camera lens and display. Find the spot on your windshield where you would like to mount the
camera and confirm the placement. Reminder, this is an adhesive mount, so it is important to mount
correctly the first time. Next, peel the plastic film off the 3M adhesive and press the mount FIRMLY onto
the windshield.
POWER
Plug one end of the supplied 12V Vehicle Power Adapter into your vehicle’s cigarette lighter, and the
other end into the micro USB port. The unit will automatically turn on and start recording. To manually
power on the device PRESS AND HOLD the Power button until the display activates.
Note: A Hardwire Kit is available at www.cobra.com for a more permanent installation that allows for
discrete routing of the power cable and recording while your vehicle is off.
DRIVE!
Your dash cam is designed for easy operation. After powering the camera will instantly begin loop
recording. When the MicroSD Card is full the oldest footage will be deleted to make way for the new. If
you witness something that you do not want deleted simply press the Emergency Record button and it
will be saved.
Operation
To Next Page
Loading...
Need help?
General
